KUHN GA 8001 H, Руководство по сборке и эксплуатации

Страница: 16 / 52

- 14 -
5. Parking the machine (photo B)
- Pull on lock handle (23).
- Slide parking stand (24) until lock (23) automatically locates in place.
ATTENTION : Always double check lock (23) is engaged.
- Raise the frame using a hoist and remove the trestles.
- Lower the machine and park it on the ground.
4. Finishing of the rear undercarriage mounting (figure 3)
- Mount the pre-assembled mudguards (1) on the wheel arms (2) using 12 self-tapping screws (M 8 x 20) packed
in the mounting hardware marked « montage garde-boue » 078 714 00.
- Mount the wheels(3) on hubs (4) using 12 wheel nuts (5) (torque : 10 daNm / 75 ft.lbs).
- Place 6 self-sticking supports(6) with their clamp collars on the rear sub-frame. Pull the electric wire with the
white end (7) through the left crossbar (8) (seen in the direction of travel) and the electric wire with the black
end (9) through the right crossbar.
- Mount the pre-assembled rear signalling panel units (10) on the rear wheel frame (11) using 6 self-locking
screws (12) (M 10 x 25). The red corners must be pointing upwards and outwards.
- Mount the tine arm supports (13) and the cover plate (14) on the rear wheel frame (11) with 12 self-tapping
screws (15) (M 8 x 20), 12 plain washers (diameter 9 x 30 x 1,5), 4 self-locking screws (16) (M 10 x 25).
- 2 self-tapping nuts (15) (M 8 x 20) are used to fit the SMV support.
- Plug the 4 pin terminals into the rear lights (17). Note that the rear left light connector is marked "L" and
is identified by a white cable sheath (highlighted in grey on fig. A).
The locking tab (19) of the female connector (20) must be fully engaged over the peg (21) of
the male connector (22) (fig. A). The cable ends should be slightly slack. Tighten the collars starting with
the rear of the machine.
- Place the bushes (18) in the tine arm storage racks (13).
The necessary mounting hardware for the cover plate (14), the rear signalling panels (10), the electric wires (7
and 9) and the tine arm storage racks (13) are located in the parcel marked «montage des panneaux de
signalisation arrière» 078 708 10.