KUHN GA 8001 H, Руководство по сборке и эксплуатации

Страница: 14 / 52

- 12 -
ASSEMBLY INSTRUCTIONS
According to their destination, GA 8001 H units can be packed in crates, some parts or part units being
disassembled to facilitate their packing-up.
For reduced bulk, the main beam of the machine frame is not packed in a crate. To mount the various parts,
proceed as follows :
1. Unpacking
Carefully unpack all parts and spread them on the ground for easier identification.
The various hardware bags are numbered for easier identification. Make sure to use the hardware bag number
indicated in the various assembly sections.
2. Assembly of the rear undercarriage to the frame (figure 1 and photo 1 A)
- Place the frame (1) on trestles and remove the support (S) which can be stored away together with its mounting
hardware.
- Using a hoist, bring the rear undercarriage (2) close to the frame (1).
Assemble both parts together with the 20 self-locking screws (3) (M 16 x 35) and 20 self-locking nuts (4) (M
16) located in the hardware parcel marked «montage train arrière» 078 709 10. Torque : 28 daNm/ 200 ft.lbs.
3. Mounting of the front signalling panels (photo 2)
- Mount the pre-assembled front signalling panels (4) on each side of the headstock (5) using 4 hexagonal screws
(6) (M 10 x 60) and 4 self-locking nuts (M 10). The red corners must be directed towards the top and outer side
of the machine.
- Fit the 2 self-adhesive bases (7) on each panel support (4) and place 1 collar (10) in each base.
- Connect the terminals (8) of the wiring harness in terminals (9) of the front lights. The locking tab (19) of the
female connector (20) must be fully engaged over the peg (21) of the male connector (22) ( see figure
A, page 15).
- Tighten the collars.
The necessary mounting hardware is located in the parcel marked « montage panneaux de signalisation avant »
078 707 00.