Kugelmann Maschinenbau DUPLEX INOX, Руководство по эксплуатации

Страница: 38 / 50

Pulses/kg teach-in left or right (each conveyor screw separately)
Press left-hand turning knob as long as at least 1800 pulses are reached
set the weighed net weight at the middle turning knob
save the value by means of the right-hand turning knob with “OK”
Setting of spreading image
Let the vehicle run in neutral gear at an appropriate place with the spreading material container possibly half
filled. If no hydraulic system with performance-dependent delivery volume (load sensing) is available, switch
on hydraulic system at the vehicle.
Never work in the vicinity of the machine in loose clothing. It can get caught in moving parts.
Do not execute any work with the machine operating!
SWITCH OFF THE MOTOR AND REMOVE THE IGNITION KEY!!!
After switching off the machine, tooling/machine parts may continue running!
Manual operation with k-tronic: Press button at bottom left and hold it pressed press button at top right
release both buttons press button at top right again (spreading operation) screws and
spreading disc are rotating
After a few seconds, switch off the hydraulic drive and the vehicle.
Observe the above-mentioned safety instructions. The spreading image can be evaluated by means of the
distribution of the spreading material on the ground.
The distribution of spreading material has to be executed according to the requirements and test methods for the
distribution of spreading material (TLG B3).
Subject to modifications
38
_Operation of spreader