Kugelmann Maschinenbau DUPLEX INOX, Руководство по эксплуатации

Страница: 45 / 50

Spreader with brine tanks
Before removing the spreader after the end of the season, clean the brine tanks with clear water. Connect C
pipe and rinse tanks thoroughly. Do not let the feed pump for brine run dry. Fill it with Glysantin during
summer.
Replacing the sensors at the conveyor screws and at the spreading disc
If no feedback arrives at the control system, the respective sensor may be defective. Check the oil supply and
check whether the conveyor screws are blocked.
Slacken fixture, turn out sensor and separate from cable. Mount new sensor, solder cable or clamp at slave.
Replace defective sensors immediately. Danger from rotating tooling! Switch off the vehicle and
remove the ignition key!
Wear parts
Wear parts are: the spreading disc
both conveyor screws, the
chain and the chain wheels
the bearings of the spreading disc and conveyor screws, all
light bulbs
all oil and water filters
all hydraulic hoses are to be replaced every 6 years
all hoses and collars
Tarpaulin cover and splash guard at rear face
Observe the safety rules concerning the handling of hydraulic lines, couplings and parts in
Chapter 1. Damaged hydraulic hoses must not be repaired, they must be replaced immediately.
Subject to modifications
Chapter 06_
45
www.kugelmann.com