Kugelmann Maschinenbau DUPLEX INOX, Руководство по эксплуатации

Страница: 29 / 50

Set the overpressure valve to a pressure of 180 bar. The PTO speed must be set to 540 1/min. When
removing the spreader, the PTO hydraulic pump is mounted on a device installed for this purpose. The oil
level at the pump has to be checked in regular intervals.
Remove the rear support legs before spreading; see Chapter 5 Operation of spreader.
Removal of spreader
The rear support legs must be mounted and in correct position. Lower the three-point spreader completely.
The ground must be even and stable. Uncouple the hydraulic hoses, the hydraulic hose for the pressure-free
return at the end. Disconnect the 7-pole connector of the lighting bar.
At the control system MCSS 3/4, disconnect the three socket connections (described at installation).
With the k-tronic and the fixed variant, disconnect the 19-pole connector from the socket.
k-tronic and removable spreader connections. Disconnect the socket connection for the master, the control
cable and the current supply at the terminal box. Furthermore, disconnect the socket connections for the
current supply and the drive signal at the permanently installed connecting sockets in the driver’s cabin.
Installation ready for operation
Proceed as described in Chapter 4, page 2.
Use the documentation “Installation guide electrical system” for the electrical connection.
Subject to modifications
Chapter 04_
29
www.kugelmann.com