Kubota LA344, Руководство по ремонту

Страница: 63 / 74

14. Raise the boom until the bucket-fulcrum-pin comes
up to the height of the boom-fulcrum-pin.
(1) Bucket fulcrum pin (2) Boom fulcrum pin
15. Make sure that the stand lever is at its low position
as shown in the following figure.
(1) Stand lever
16. Slowly dump the bucket until the stand touches the
boom.
17. Slide the stand lever upward direction, and then
slide the stand lever left side completely as shown
in the following figure.
(1) Stand lever
18. Hold the stand by stand hook.
(1) Stand (2) Stand hook
4.2 Bucket, boom and hydraulic
cylinders
4.2.1 Attaching attachments
DANGER
To avoid personal injury or death
• Use of a non-KUBOTA attachment that does not
comply with ISO24410 or the improper
positioning of handle(s) or non-protrusion of
pin(s) may result in detachment of the
attachment or deformation, causing loss of
performance, personal injury, or death.
NOTE
• Locate the attachments on a flat, firm surface
when attaching and removing them from the
quick-attach-coupler.
The quick-attach-coupler is designed to be used with
KUBOTA
attachments. To use non-KUBOTA
attachments, it must comply with ISO 24410, first
edition 2005-04-15. The quick-attach-coupler allows the
operator to change the attachments easily without the
use of tools.
1. To mount an attachment, pull the quick-attach-
coupler-handles to the unlatched position to release
the latching pins. Move the quick-attach-coupler-
handles all the way up to ensure that the latching
pins are fully retracted.
3. FRONT LOADER
SERVICING
4.Disassembling and assembling
3-26
LA344, LA344S
KiSC issued 02, 2017 A