Kübler SMC1.3, Руководство по безопасности

Страница: 172 / 235

R60047.0002 - Index 2 EN – page 52 / 115
9.6 Wait Time
The Wait Time parameter defines the frequency below which all frequencies will be
taken as zero. Setting of e.g. 1.0 second will result in zeroizing all frequencies lower than
1 Hz. In this context it must be clarified whether the application requires a standstill- or
drift-monitoring or not.
1. Where the application does not require any standstill or direction or drift control,
you are free to set Standstill Time with regard of the expected minimum
frequency and the required response time only.
2. Where the application uses standstill control, please observe also possible jitter
during standstill and adjust Wait Time correspondingly.
3. Where the application uses forward/reverse direction control, also possible jitter
should be considered while the system holds in closed loop position control.
No. Parameter Remark
001 “Wait Time” Adjust the zero balancing window
9.7 F1-F2 Selection
This parameter is used to determine the base frequency. When the original frequency of
sensor 1 is higher than the original frequency of sensor 2, the parameter F1-F2-Selection
is set to 0, otherwise to 1. The higher frequency is used to set the switching points,
because it is more stable.
No. Parameter Remark
003 „F1-F2
Selection”
When Frequenz 1 > Frequenz 2, parameter is set = 0 (F1 selected).
When Frequenz 2 < Frequenz 1, parameter is set = 1 (F2 selected).