Kübler SMC1.3, Руководство по безопасности

Страница: 146 / 235

R60047.0002 - Index 2 EN – page 26 / 115
5.10 SMCB Operator Interface
On the front site the unit provides a serial interface for communication with SMCB
operator units (optional accessory), allowing display and parameter setting.
8-pin female connector [X11]
The SMCB unit and the safety monitor are connected by plugging the SMCB directly onto
the female 8-pin connector [X11] at the front.
This operator unit is intended for display of the encoder signals (in user units) and for
visual monitoring of the SMCX unit.
With the SMCB no parameters can be changed in the SMC2.4/SMC1.3.
The user interface OS 6.0 is required for Start-up and commissioning.
The female connector [X11] is reserved for exclusive use with a SMCB
unit.
5.11 USB Interface for the OS6.0 Operator Surface
For communication between the unit and a PC or a superordinate controller, a virtual
COM port is accessible at the USB connector. A standard USB-cable with a Type B
connector is used for connection. This USB cable is available as an option. The USB port
serves for PC setup of the DS monitors.
USB - Typ B
A separate manual is available describing the installation procedure of the USB driver
(see page 2).