Kübler SMC1.3, Руководство по безопасности

Страница: 145 / 235

R60047.0002 - Index 2 EN – page 25 / 115
5.9 DIL switch
A 3-position DIL switch [S1] is located at the front of the unit
(only accessible when no display and programming unit SMCB is connected).
3-pos DIL switch [S1]
The DIL switch is used to set the operation state of the monitor:
DIL1 DIL2 DIL3 Status Info
ON ON ON
Normal
Operation
Device in normal operation.
Yellow LED off (lights up permanently at error state).
Ready for operation approx. 10 s after power up
ON --- OFF
Programming /
Test - Mode
Device in programming or test mode, e.g. Start-up.
Yellow led blinks slowly (lights up permanently at error
state)
--- OFF ---
Self Test
Message
For internal testing
After power-up the device sends a log of the self tests.
Yellow led blinks slowly (lights up permanently at error
state). Ready for operation approx. 15 s after power up
OFF --- ---
Factory Settings
After power-up the Unit is reset to factory Setting.
All parameters are overwritten with default values.
Yellow led blinks slow
l
y (lights up permanently at error
state.
•
The Programming Mode (DIL switch) is used for Start-up and
testing
•
All DIL switch sliders must be set to „ON“ after Start-up and
testing
•
After Start-up the DIL switch sliders should be protected against
manipulation (e. g. by covering with the adhesive tape)
•
Normal operation is only permitted when the yellow LED is
permanently off
•
The safety function of the unit cannot be guaranteed before the
commissioning has been completed.