KTR-STOP
®
XS-xx-F B-xx
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
44536 EN
12 of 25
3
Please observe protection
note ISO 16016.
Drawn:
2020-03-26 Shg/Wie
Replacing:
KTR-N dated 2017-12-19
Verified:
2020-03-26 Shg
Replaced by:
The centering system needs to be reset with initial assembly or after having replaced brake
pads or single parts, respectively. Only in this way it is ensured that the gap between the
brake disk and the brake pad on the bottom side is set to the right value and the pad does
not touch on any side.
The centering system has to be reset regularly with wear of the brake pads. For that
purpose repeat the complete chapter Setting/resetting of the centering system.
•
Measure the gap between the brake disk and the brake pad on the bottom side via a feeler gauge.
•
Set the gap to 0.5 mm or the figure x requested (see illustration 10), respectively, by screwing the hexagon
nut marked with 1 in illustration 11 either upwards or downwards.
•
Counter the hexagon nut with the hexagon nut marked with 2 in illustration 12.
Illustration 10: Setting of gap
Illustration 11: Setting of centering system
The gap between brake disk and brake pad needs to be 0.5 mm on both sides to ensure the
brake power.
4
Assembly
4.5 Setting/resetting of the centering system
