KTM 50 SX MINI 2010, Руководство пользователя

Страница: 34 / 85

MAINTENANCE WORK ON CHASSIS AND ENGINE
32
9.26
Handlebar position
0 0 0 B B
0 0 A A
400565-10
On the upper triple clamp, there are 2 holes at a distance of

to each other.
Distance

between holes 15 mm (0.59 in)
The holes on the handlebar support are placed at a distance of

from the center.
Distance

between holes 3.5 mm (0.138 in)
The handlebar supports can be mounted in 4 different positions.
9.27
Adjusting handlebar position
x
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
0 0 1 1
0 0 2 2
400564-10
–
Remove the four screws

. Remove the handlebar clamp. Remove the handlebar
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws

. Remove the handlebar support.
–
Place the handlebar support in the required position. Mount and tighten the two
screws

.
Guideline
Screw, handlebar support M10 40 Nm
(29.5 lbf ft) Loctite ® 243™
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Mount and evenly tighten the four screws

.
Guideline
Screw, handlebar clamp M8 20 Nm
(14.8 lbf ft)
Info
Make sure the gap width is even.
9.28
Checking the play in the throttle cable
700481-10
–
Move the handlebar to the straight-ahead position.
–
Push back bellows

.
–
Pull back the throttle cable casing until you sense a resistance.
–
Now check throttle cable play

.
Play in gas throttle cable 3… 5 mm (0.12… 0.2 in)
» If the throttle cable play does not meet specifications:
–
Adjust the play in the throttle cable.
x
( p. 33)
–
Push on bellows

. Check the throttle grip for smooth operation.