Krone Titan 6/50 GL, Руководство по эксплуатации, Страница: 32 / 134

III - 8
Operation
3.7 Cutting unit
3.7.1 Special safety instructions
The following applies during all maintenance, assembly, repair and adjustment work:
• Shut down the short-cut loading wagon.
• Shut down the engine, remove the ignition key and switch off the electrical supply at the
control box.
• Secure the tractor and short-cut loading wagon against rolling away.
• When installing and removing the cutter, there is a high risk of injury from cuts. Only handle
the cutter while wearing suitable gloves.
• The cutter is installed and removed from underneath the loading wagon. Always support the
short-cut loading wagon on the secured stabilising foot.
3.7.2 General information
The cutting unit has 35 individual cutters which are
protected against foreign objects.
Either 0, 17, 18 or 35 cutters can be switched in,
according to choice, via the central cutter switch.
The cutters are arranged in on level. Theoretically, the
shortest cutting length is 40 mm. Longer lengths can be
achieved by swinging the cutter sets away using the
central adjustment (see Table).
The cutting unit has a hydraulic cutter-
0-system, so that if there are any blockages, the cutter
can be swung out of the conveyor channel hydraulically
via the control unit on the tractor.
Cutting length Number of cutters
cutter unit
Set
front (1)
Set
rear (2)
- 0 off off
~ 80 mm 17 on off
~ 80 mm 18 off on
~ 40 mm 35 on on
3.6 Roll-type crop guard
The roll-type crop guard is an accident
preventing device and must not be
removed during field operation.
When handling bis swaths the roll-type crop guard (1) can
be adjusted to match the crop density.
For this the chains (2) must be attached in a higher
position.
XXL00001
TR000002
17 18