Krone Comprima V 180, Оригинальная инструкция по эксплуатации, Страница: 87 / 242

Operation 8
Using the bale ejector 8.14
Comprima V 180
Original Operating Instructions 150001053_00_en 87
X
1
2
RP000-024
ü
A round bale is pressed with chamber film wrapping and set down in the field.
ü The machine is shut down and safeguarded, refer to page 25 .
„
Use a marker pen to draw 2 horizontal lines (1) on the film at a distance of X=100 mm .
„
Cut out the section (2) around the 2 lines which you have drawn. Ensure that you cut out all
film layers.
„
Allow all film layers of the cut-out section (2) to rest for at least 3 minutes.
„ Measure the distance X between the lines (1) which you have drawn.
Æ
If the distance X is between 86 and 95 mm, the pre-tension has been correctly set.
Measured value
X Pre-tension Evaluation
< 86 mm > 15% The pre-tension is too strong. Reduce the brake force
on the wrapping material brake,
refer to page 151 .
86 mm 15% Correct
95 mm 5% Correct
> 95 mm < 5% The pre-tension is too weak. Increase the brake force
on the wrapping material brake,
refer to page 151 .
INFORMATION
KRONE recommends 3.5-4 film layers to ensure optimum chamber film wrapping, refer to
page 119 . The minimum required film layers depend on the condition of the crops.
For round bales with a diameter greater than 130 cm and/or very dry or very wet crops,
KRONE recommends using at least one additional film layer.
8.14 Using the bale ejector
1
RP000-502