Krone Comprima V 180, Оригинальная инструкция по эксплуатации, Страница: 215 / 242

Malfunction, cause and remedy 17
Faults of the electrics/electronics 17.5
Comprima V 180
Original Operating Instructions 150001053_00_en 215
Possible cause Remedy
FMI 7: The net has not been pulled.
The net roll has the wrong di-
mensions. „
Only use net rolls with the prescribed dimensions, refer to
page 40 .
The net roll has not been cor-
rectly inserted into the roll
holder. „ Insert the net roll according to the description.
For "Net wrapping" version:
refer to page 80 .
For "Net and chamber film wrapping" version: refer to
page 82 .
„
Check in particular the net overhang. Ensure that it is at
least 250 mm.
The wrapping material brake
does not release. „
Adjust the wrapping material brake, refer to page 150 .
„
Check the axial play of the wrapping material brake, refer to
page 187 .
The net is pulled earlier even
though the feed rocker arm is
not yet in feed position.
„
Check the sensor B02 "Tying process active".
„ Check the sensor B61 "Tying 1 (passive)" and set the feed
position,
refer to page 136 .
522020-
Chamber film wrapping
Possible cause Remedy
FMI 7: The film has not been pulled.
The film roll has the wrong di-
mensions. „ Use only film rolls with the prescribed dimensions, refer to
page 40 .
The film roll is not correctly in-
serted into the roll holder and/
or the brake force release has
not been set correctly.
„
Insert the film roll according to the description, refer to
page 82 .
„
Check and set the brake force release during the feed
process,
refer to page 149 .
The film overhang is too short.
„
Check the film overhang. Ensure that it is at least 250 mm.
The actuator for wrapping pro-
cess is defective. „ Check the actuator for wrapping process.
522021-
Net wrapping
Possible cause Remedy
FMI 7: The net stops during activated tying. The net tears off after the starting process or dur-
ing tying.
The roll brake has been set
with too much force. „ Check the setting of the roll brake.
The cutting unit has lowered
into the net.
„
Remove contamination from the cutting unit.
„ Check the setting of the cutting unit.
„
Check whether the cutting unit is engaged/clamped during
the feed process.
The cutting unit has not en-
gaged.
The cutting unit has been set
too deep.
522021-
Chamber film wrapping