Krone Comprima V 180, Оригинальная инструкция по эксплуатации, Страница: 76 / 242

8 Operation
8.10 Pick-up
76
Comprima V 180
Original Operating Instructions 150001053_00_en
8.10.2 Setting the pick-up working height
RP000-151
The working height of the pick-up (3) must be set so that the distance between the tines and the
ground is approx.
20-30 mm . Also the working height of the pick-up (3) must be adjusted to the
ground conditions.
ü The machine is shut down and safeguarded, refer to page 25 .
Make the following setting on the right and left sides of the pick-up in the same way:
„ Remove the linch pin (2).
„
Push the perforated bar (1) into the required position and secure with linch pin (2).
„
Lower the pick-up (3) hydraulically.
„ Check whether the distance between the tines and the ground is approx. 20-30 mm .
„
If required, re-adjust the perforated bar (1).
„ Check whether the drawbar height of the machine must be adjusted to the tractor, refer to
page 46 .
Setting the pick-up working height more precisely
RP000-152
If ground conditions are extreme, the height of the pick-up can also be set via the chain (2). To
do this, the pick-up can be set higher or lower by one complete chain link or even more
precisely via the chain holder (1).
When used in straw, the pick-up should be set as high as possible off the ground. Then use the
chain (2) to adjust the castor-mounted guide wheels so that they do not touch the ground.
ü
The machine is shut down and safeguarded, refer to page 25 .
ü
The pick-up is fully raised in transport position, refer to page 75 .
ü The guide wheels are folded upwards.