Krone AMT 4000 CV, Руководство по эксплуатации

Страница: 6 / 46

4
,
22.Persons are not allowed to enter the working area!
23.Keep clear of the area of rotation and tilt of the
attachment!
24.Hydraulic joint controls must only be operated if no
persons are in the danger area!
25.Power operated elements (e.g. with hydraulic control)
contain danger points which can cause injury by
crushing and shearing!
26.Before leaving the tractor, rest the mowing attachment
on the ground, switch off the engine and remove the
ignition key!
27.Make sure that nobody enters the area between the
tractor and the implement unless the tractor is protected
from rolling by the parking brake and/or wheel blocks!
3. Attached equipment
1. Take steps to prevent implements from rolling!
2. Take care not to exceed the maximum permitted load
of the trailer coupling, adjustable drawbar or hitch
coupling!
3. When using a drawbar, make sure that the coupling
point has sufficient freedom of movement!
4. Power take-off shaft operation
1. Only the PTO shafts prescribed by the manufacturer
may be used!
2. The protective tube and funnel of the PTO shaft and the
power take-off shaft protector (including the mower
side) must be fitted and in good condition!
3. Observe the tube overlap prescribed for PTO shafts in
transport and operating position!
4. Before installing and removing the PTO shafts, make
sure that the power take-off shaft and the engine are
turned off and the ignition key is removed!
5. When using PTO shafts with an overload or free-
running coupling that is not covered by the guards on
the tractor, the overload or free-running couplings must
be attached to the implement side!
6. Always ensure correct assembly and securing of the
PTO shaft!
7.Protect the PTO shaft guard from rotating with the shaft
by fitting the chains.
8.Before switching on the power take-off shaft, make
sure that the tractor’s selected p.t.o. speed matches
the permitted speed of the machine!
9.Before switching on the power take-off shaft, make
sure that nobody is in the danger area of the mowing
machine!
10.Never switch on the power take-off shaft when the
tractor engine is turned off!
11.Any work with the power take-off shaft must only be
carried out when nobody is in the area of the rotating
power take-off shaft.
12.The power take-off shaft should always be turned off
when the angle is too great and it is not required.
13. Danger! Working elements continue to rotate after the
power take-off shaft is turned off. Do not approach the
machine during this time! Work on the machine must
only be carried out when the machine is fully stationary
and the rotating parts have been secured with the
parking brake.
14.Cleaning, lubrication or adjustment of the PTO shaft or
of equipment driven by the power take-off shaft may
only be carried out when the power take-off shaft and
the engine are turned off and the ignition key has been
removed. Rotating parts must be secured with the
parking brake.
15.Rest the detached PTO shaft on the support bracket
provided.
16.After disassembling the PTO shaft, place the protective
cover on the stub of the power take-off shaft.
17.Any damage must be repaired immediately before any
work is carried out with the attachment!
5. Hydraulic system
1.The hydraulic system is pressurized!
2.When connecting hydraulic cylinders and motors, make
sure that the hydraulic hoses are correctly connected.
3.When connecting hydraulic hoses to the tractor’s
hydraulic system, make sure that all pressure has first
been released from the hydraulics of both the tractor
and the implement.