Krendl 500, Руководство пользователя, Страница: 36 / 59

Rev. Date: 3/14/18 Page 33
MODEL #500
PARTS LIST
The manufacturer recommends that all repairs be made at its own factory service center. Machine repair
done by the manufacturer is warranted for 90 days on repair parts and workmanship.
If you choose to have repairs made elsewhere, we offer replacement parts that have been carefully
inspected to insure they meet the specifications of the original part. Any disassembly and reassembly of
the unit to replace the defective part must be done with care to insure proper fit and alignment. No warranty
consideration will be extended on parts that appear to be mishandled. All units should be run for a few
minutes without material to insure proper alignment. All questions regarding replacement of parts should
be directed back to the factory.
IMPORTANT: Certain information is needed concerning your specific machine when ordering replace-
ment parts:
• Machine Model number (i.e. Model #500)
• Serial Number
• Date Purchased
• Voltage of unit (main input): 120V, 240V or 230V (overseas) - single or double input
• Main input power - single phase (1O)
• Cycle: 50 or 60 hz. (U.S. and North American models are 60 hz.)
( Most overseas units are 50 hz. Check invoice for correct cycle.)
• Blowers: single or double • Size: large 3-stage 12.5 amp (6 amp overseas)
or small 2-stage 8 amp (4 amp overseas)
• With or Without Shredder
If this information is not known, contact supplier with serial number of machine. This information is needed
on mechanical parts as well as electrical components. (Due to mechanical adjustments that compensate
for electrical requirements, the above information is needed.)