42
5.
Load hex file by entering to File -> Load Hex File…
6.
Press Run. If all process passed OK, you will receive the following window where all
check boxes will be green and at the left bottom there will be a Memory verify pass
message.
5.5
End of programming process
1.
Turn off the equipment power supply.
2.
For CI5000 module:
a.
Move two jumpers in PROG back to left 5-6 to 1-2 and 7-8 to 3-4.
See figure 19 above.
b.
If MC2 was programmed – move MC2 microcontroller back to MC2 socket, and
place MC1 in its socket. See figure 20 above.
c.
Disconnect programming cable.
3.
For ED5000 module:
a.
After using the ‘CAB 167’ cable, reconnect the ED5000 as it was connected
before.
4.
Turn on the equipment power supply.
