Kortho H210 AM, Руководство пользователя

Страница: 12 / 39

Kortho
Hot Quickcoder User manual
12
4 INSTALLATION OF THE HOT QUICKCODER
4.1 Assembly instructions
Figure 7a: options for coding products Figure 7b: options for coding lengths of film
See Figure 7 for a summary of the options. During assembly ensure that sufficient space is left
around the coder to replace the Hotroll and to change the text head. If necessary, set up the coder so
that it revolves. The dimensional sketches are included in Appendix D.
1. Mark the desired position of the holes for assembling the support (pitch is 70 mm). When
determining the position, take account of the fact that the text head (in the marked position)
should ultimately be located approx. 2-3 mm from the product surface to be printed (figure
7b).
2. Drill the fixing holes for the support (diameter 6.5 mm of M6).
3. Assemble the support with M6 bolts (x2).
4. Fix the coder to the support.
5. Mark the desired position of the holes for assembling the Control box (pitch is 70 mm).
6. Drill the fixing holes for the Control box (diameter 4.5 mm of M4).
7. Assemble the Control box with M4 bolts and/or nuts (x4).
4.2 Connection instructions
1. Disconnect the printer from the voltage by removing the mains cable from the Control box.
2. Open the Control box.
3. Check that the desired power supply is set correctly. (see appendix C).
4. Connect a sensor to supply the print command. The connection points and settings of the
switch and jumpers are given in appendix C.
5. Connect the power and control cable to the coding part.
6. Connect the Control box to the compressed air supply (setting ± 4 bar) via the reducing
valve.
7 . Connect the HQC to a grounded connection.
!
WARNINGS:
Before opening the control of the Hot Quickcoder, it should forst be disconnected from the power. This
is done by removing the mains cable from the Control box (see figure 5).
Only an GROUNDED cable may be used for connecting the equipment!