Safety Instructions
Grounding Methods
The following measures help to avoid electrostatic damages to the device:
1.
Cover workstations with approved antistatic material. Always wear a wrist
strap connected to workplace as well as properly grounded tools and
equipment.
2.
Use antistatic mats, heel straps, or air ionizers for more protection.
3.
Always handle electrostatically sensitive components by their edge or by their
casing.
4.
Avoid contact with pins, leads, or circuitry.
5.
Turn off power and input signals before inserting and removing connectors or
connecting test equipment.
6.
Keep work area free of non-conductive materials such as ordinary plastic
assembly aids and styrofoam.
7.
Use field service tools such as cutters, screwdrivers, and vacuum cleaners
which are conductive.
8.
Always place drives and boards PCB-assembly-side down on the foam.
Instructions for the Lithium Battery
The installed motherboard or SBC card is equipped with a Lithium battery
(depending on the system configuration ordered). For the replacing of this battery
please observe the instructions described in the “Fehler! Verweisquelle konnte
nicht gefunden werden.” chapter.
Warning
Danger of explosion when replacing with wrong type of battery.
Replace the battery only with UL listed Lithium battery that has the
same or equivalent type recommended by Kontron
Do not dispose of lithium batteries in general trash collection.
Dispose of the battery according to the local regulations dealing
with the disposal of these special materials, (e.g. to the collecting
points for dispose of batteries).
10
KISS 2U - User’s Manual (Version 1.01)
