886LCD-M Family
KTD-00474-E
Public User Manual
Date: 2005-05-24
Page
8 of 78
!
!
2. Installation
procedure
2.1 Installing the board
To get the board running, follow these steps. In some cases the board shipped from KONTRON Technology
has CPU, DDR DRAM and Cooler mounted. In this case Step 2-4 can be skipped.
1. Turn off the power supply.
2. Insert the DIMM DDR 184pin DRAM module(s). Be careful to push it in the slot(s) before locking the
tabs. For a list of approved DDR DRAM modules contact your Distributor or FAE (list under preparation).
DDR333, DIMM 184pin DRAM modules are supported.
3. Install the processor. The CPU is keyed and will only mount in the CPU socket in one way. Use the
handle to open/ close the CPU socket. Intel Pentium M and Celeron M processors (Banias processors)
are supported.
4. Use heat paste or adhesive pads between CPU and cooler and connect the Fan electrically to the
FAN_PROC connector.
5. Insert all external cables for hard disk, keyboard etc. except for flat panel. A CRT monitor must be
connected in order to change CMOS settings to flat panel support. To achieve UDMA-66/100/133
performance on the IDE interface, 80poled UDMA cables
must
be used. If using the IDE_S2 connector
care should be taken in correct orientation when attaching the female cable. The cables that KONTRON
provide do not have a key. There is possibility of damage to the HDD or PCB if the cable is not orientated
correctly.
6. Connect power supply to the board by the ATXPWR connector.
7. Turn on the power on the ATX power supply.
8. The PWRBTN_IN must be toggled to start the Power supply; this is done by shorting pins 16
(PWRBTN_IN) and pin 18 (GND) on the FRONTPNL connector (see Connector description). A “normally
open” switch can be connected via the FRONTPNL connector.
9. Enter the BIOS setup by pressing the “F2” key during boot up. Refer to the Software Manual (under
preparation) for details on BIOS setup.
Enter Advanced Menu / CPU Configuration / Intel SpeedStep Tech. and set this option to “Maximum
Performance”.
Note
: To clear all CMOS settings, including Password protection, move the CMOS_CLR jumper (with or without
power) for approximately 1 minute. Alternatively turn off power and remove the battery for 1 minute, but be
careful to orientate the battery corretly when reinserted.
Note
: If the Audio Amplifiers shall be used to generate up to 3W on one or more of the
Audio ouput channels, then make sure that sufficent airflow is around the Audio
Amplifier. The Amplifier has integrated Thermal Protection and will not be damaged
even though the airflow is insufficient for normal operation.
Warning
: Do not use Power Supply without 3.3V monitoring watchdog, which is
standard feature in ATX Power Supplies.
Running the board without 3.3V connected will damage the board after a few minutes.
