886LCD-M Family
KTD-00474-E
Public User Manual
Date: 2005-05-24
Page
58 of 78
8.3.2 Advanced settings – IDE Configuration
BIOS SETUP UTILITY
Main Advanced
PCIPnP
Boot Security Chipset Power Exit
IDE Configuration
IDE Configuration [P-ATA Only]
S-ATA Running Enhanced [Yes]
P-ATA Channel Selection [Both]
S-ATA Ports Definition [P0-3
rd
./P1-4th]
Configure S-ATA as RAID [No]
Primary IDE Master : [Hard Disk]
Primary IDE Slave : [Not Detected]
Secondary IDE Master : [Not Detected]
Secondary IDE Slave : [Not Detected]
Third IDE Master : [Not Detected]
Third IDE Slave : [Not Detected]
Fourth IDE Master : [Not Detected]
Fourth IDE Slave : [Not Detected]
ATA(PI) 80Pin Cable Detection [Host & Device]
P-ATA1 Cable Detection force [Disabled]
P-ATA2 Cable Detection force [Disabled]
Hard Disk Write Protect [Disabled]
IDE Detect Time Out (Sec) [35]
Select IDE Mode.
P-ATA Only:
4 P-ATA & 2 S-ATA
S-ATA Only:
2 S-ATA
P-ATA & S-ATA
2 P-ATA & 2 S-ATA
<- Select Screen
|| Select Item
+- change option
F1 General Help
F10 Save and Exit
ESC Exit
V02.53 (C)Copyright 1985-2002, American Megatrends, Inc.
Feature
Options
Description
IDE Configuration
Disable,
P-ATA
Only
, S-ATA Only,
P-ATA & S-ATA
Setup the configuration of the hard drive
interfaces
When P-ATA & S-ATA mode is selected:
Feature
Options
Description
Combined Mode Option
P-ATA 1st Channel,
S-ATA 1st Channel
Setup the configuration of the hard drive
interfaces
S-ATA Ports Definition
P0-Master/P1-Slave,
P0-Slave/P1-Master
Select physical ports (P0/P1) to be Master/Slave
or Slave/Master
When S-ATA only mode is selected:
Feature
Options
Description
S-ATA Ports Definition
P0-1st./P1-2nd.,
P0-2nd./P1-1st.
Select physical ports (P0/P1) to be 1st./2nd. or
2nd./1st.
When P-ATA only mode is selected:
Feature
Options
Description
S-ATA Running Enhanced
Mode
Yes, No
Setup the S-ATA interface to be running in
enhanced mode or legacy mode
P-ATA Channel Selection Primary,
Secondary,
Both
Setup the active IDE channels
S-ATA Ports Definition
P0-3
rd
./
P1-4
th
,
P0-4
th
./P1-3
rd
Select physical ports (P0/P1) to be 3
rd
/4
th
or
4
th
/3
rd
Configure S-ATA as RAID
No
, Yes
Only available when "P-ATA Only" is selected.
Note: Install the driver via USB-Floppy
connected to USB port 2 (lower conn.)