Konica Minolta CA-100PLUS, Инструкция по эксплуатации

Страница: 72 / 125

70
[Setting Procedure]
1
5
3
2
4
1
. Press the MODE key to select the measurement mode
for which you want to set the range.
2
. Press the key.
The LCD display section will switch to the menu selection screen.
3
. Press the key to open the RANGE setting screen.
Each time the key is pressed, the screen will switch in the order
PROBE → SYNC → ID Name input → RANGE → Measurement
Speed → Number of Digits → RS232C Baud Rate → PROBE.
4
. Enter the desired range value.
Use the ten-key ( to , ) to enter the value. (The cursor moves
to the right each time a value is entered.)
Each time the
key is pressed, the cursor moves between x, y and
Lv, between G and B/G, R/G or between R and B/G, R/G.
In this example, the “x, y” range is set to 2.5%, and the “Lv” range is
set to 2.0%.
1
Press the , and then key to set the “x, y” range.
2 Press the key.
The cursor (_) will move to the “Lv” position.
3 Press the , and then key to set the “Lv” range.
5
. Press the key.
The ranges will be set.
* To cancel range setting, press the key before pressing the key.
* By default (factory setting), the ranges are set to 10%.
<Error Messages in LCD Display Section>
… For other error messages, refer to page 107.
●
“E4” (after the key is pressed)
• Cause : 0.0% was entered.
•
Action : Enter a correct value and then press the key. The settable range is from 0.1 to 99%.
RANGE x,y Lv
(%) 10 10
_
RANGE G B/G,R/G
(%) 10 10
_
RANGE R B/R,G/R
(%) 10 10
MENU : SELECT
PUSH SPACE KEY
Menu selection screen
Range setting screen
(For xyLv, T
∆ uvLv, u'v'Lv
or XYZ mode)
For analyzer mode (G reference)
For analyzer mode (R reference)