Konica Minolta bizhub 601, Руководство пользователя

Страница: 444 / 538

751/601 11-48
Utility mode 11
– Each time [+] or [-] is touched, the value is increased
or decreased by one increment.
– To decrease width A, touch [-] to decrease the
adjustment (between -0.1 mm and -5.0 mm).
7
Touch [OK].
– To cancel the setting and select the default, press the [Reset] key.
The horizontal position of the punched holes is adjusted.
If no adjustment of the horizontal position of the punched holes was necessary in step 6, this completes
the procedure.
8
Use a Punch setting to print another sample copy.
9
Check the print result.
– Check that the horizontal position of the punched holes was adjusted.
– If more adjustment is necessary, repeat steps 6 through 9.
2
Note
Set the value by mm. Refer to the conversion rate below.
1 inch = 25.4 mm
11.6.7 Punch Resist Loop Size Adjustment
When printing with a Punch setting, the angle of punched holes along the side of the paper can be adjusted.
2
Note
[Punch Resist Loop Size Adjustment] appears only if optional punch kit is installed on the finisher.
For details on the Punch settings, refer to "Punching holes in copies (Punch settings)" on page 2-62 .
0 Before making any adjustments, use a Punch setting to print a sample copy. Perform the adjustment
while checking the sample that was created.
1
Display the Administrator Settings screen.
– For details on displaying the Administrator Setting screen, refer to
"Displaying the Administrator
Settings screen" on page 11-36 .
2
Touch [1 System Settings].
The System Settings screen appears.
A
A