Kongsberg Seatex AIS 100, Инструкция по эксплуатации

Страница: 55 / 113

Seatex AIS 100 Instruction Manual, rev. 5 External interfaces
47
6 EXTERNAL INTERFACES
6.1 External interfaces
Increased navigational performance can be achieved by interfacing the
Seatex AIS 100 to an ECDIS, ECS, radar, gyro or heading sensor. All
sensors are connected through the AIS 100 connection box using
serial line communication. This is normally done during installation.
VHF-transmitter
VHF-receive ch. 70
VHF-receive ch. AIS 1
VHF-receive ch. AIS 2
GPS receiver
In
terface b
o
ard
VHF
switch
AIS Transponder
GNSS/DGNSS
Antenna
VHF Antenna
Heading
GNSS
Rate of Turn
Speed
ECDIS
MKD unit
Figure 22 Interfaces to the Seatex AIS 100 mobile station
6.2 Presentation interface
The presentation interface consists of two physical ports, called PI and
pilot port. The PI port provides a primary port for connection to
onboard equipment such as ECDIS, radar etc. The pilot port provides
a port for connection to the ship's pilot equipment, service equipment,
etc. Both ports are functionally equivalent.
Port configuration
The PI and pilot port have the following default settings:
Baud Rate Parity Bits Stop Bit
38400 N 8 1
The baud rate is configurable to 57600.