Kongsberg Seatex AIS 100, Инструкция по эксплуатации

Страница: 18 / 113

Seatex AIS 100 Instruction Manual, rev. 5 Operation
10
2.2.3 Polled or controlled mode
In this mode the mobile station will automatically respond to
interrogation messages from a ship or competent authority. The
response is transmitted on the channel where the interrogation
message was received. Operation in Polled or Controlled mode does
not conflict with operation in the other two modes.
2.3 Malfunction and fallback arrangements
The mobile station has built-in integrity testing to continuously verify
own operational status and notify user and external equipment if any
malfunction is detected. Part of this test monitors the transmitter and
receiver modules. Alarm status will be transmitted to the PI port in
addition to triggering the alarm relay.
Malfunction type Malfunction source
Tx malfunction
ID 001 Tx frequency is not locked or
Tx power is measured outside setting
SWR 3:1 malfunction
ID 002 SWR is measured to more than 3:1
ChA malfunction (RX1)
ID 003 ChA frequency is not locked
ChB malfunction (RX2)
ID 004 ChB frequency is not locked
Rx DSC malfunction
ID 005 Ch70 frequency is not locked
2.4 Mobile station initialisation
The mobile station will automatically switch on when power is
applied to the unit by connecting the power cable in the connection
box. There is no on/off switch and thus power is removed by
disconnecting the power cable in the connection box.
•
After power has been applied, wait for the two-minute
initialisation period.
•
At completed initialisation all LEDs will go amber.
•
The mobile station is ready for operation when the GPS LED is
blinking at one-second intervals.
•
The View page will appear on the MKD.