Kongsberg Seatex AIS 100, Инструкция по эксплуатации

Страница: 93 / 113

Seatex AIS 100 Instruction Manual, rev. 5 Software setup procedure
85
7 SOFTWARE SETUP PROCEDURE
7.1 Description of installation setup
The AIS 100 mobile station is set up with factory settings during
testing. The installation setup must be performed as a part of the AIS
100 system installation.
The installation setup is found in the highlighted sub-menus (4, 7, 9 &
c) in the
Main Menu.
=== Main Menu ======== P1
1.
Nav.Status
2. Long Range history
3. Voyage Data
4. Static Data
5. Dynamic Data
6. Chn.Management
7. VHF Link
8. Downperiods
9. Network & Ports
a. Answer Mode
b. Diagnostics
c. Security
x.yy.zz
This is the Main Menu page for the Seatex AIS
100 with sub-menus. Press the MENU button on
the MKD unit to access the sub-menus.
In order to make changes to any data field, use the
WHEEL to select desired line and confirm with
the ENTER button. Edit the data field by selecting
the symbol (arrow with bar) and (enter) in the end
of the bottom line. Type new data entry and
confirm with ENTER.
=== Security ======== P1C
Authorisation
L1 PIN Code :*******
L2 PIN Code :*******
Nav.Status :1
Route Plan :2
Voyage Data :0
Static Data :0
Chn.Mgmt :1
VHF Link :1
Serial Ports :0
Netw.Settings :1
Answer Mode :0
Security
A default authorisation code is used for altering
the data fields in the
authorisation page. The
level 1 and 2 PIN codes control access to the listed
sub-groups. The lower level (0) gives limited
access and needs no access code. The higher level
(2) gives unrestricted access to all of the AIS 100
mobile station parameters.
All entries on this page are protected by level 2
PIN code.
Setup procedure:
Enter new PIN codes and choose suitable access
levels for the group data.
The Default PIN code 1 & 2 and a Master
Password can be handled out from Kongsberg
Seatex Custom Support.