Kongsberg Seatex AIS 100, Инструкция по эксплуатации

Страница: 103 / 113

Seatex AIS 100 Instruction Manual, rev. 5 Troubleshooting
95
between transmitting (vessel GPS/GNSS receiver) and receiving
(parameters to be checked from the MKD unit) end.
•
If OK, check that the position output format from the GPS/GNSS
receiver is in accordance with the expected input position format.
•
If the mobile station still does not receive position data, consult
Seatex for advice.
9.2.2 Heading from vessel heading sensor
Heading data is received from the vessel gyro or magnetic compass. If
input data is missing, the following steps should be taken in order to
check for missing heading data:
•
Check that cable connections are correctly terminated in the
connection box (terminal screws 19 to 27).
•
If correctly connected, check the serial line communication (baud
rate, parity, number of bytes transmitted, number of stop bits)
between transmitting (vessel heading sensor) and receiving
(parameters to be checked from the MKD unit) end.
•
If OK, check that the heading output format from the compass is
in accordance with the expected input heading format.
•
If the mobile station still does not receive heading data, consult
Seatex for advice.
If the mobile station fails to operate properly, remove power by
removing the + 24 V power supply cable and then reapply power. The
mobile station should now initialise from start.