Komatsu WA320-5H, Руководство по эксплуатации и техническому обслуживанию

Страница: 287 / 321

MACHINE MONITOR WITH LOAD METER
ATTACHMENTS, OPTIONS
6-40
4. Press the ( ) of monitor panel selector switch 1. “EMPTY
BUCKET“ is displayed on the bottom line.
5. Press the ( ) of monitor panel selector switch 1. The dis-
play changes to “STEP 1“ on the top line, and “FULLY
ROLL BACK“ and “AT CARRY POSI“ are displayed in turn
for 3 seconds each on the bottom line.
6. Follow the instructions on the screen, tilt the empty bucket
back fully, then lower the lift arm to set to the travel posture.
7. When the lift arm is lowered, the display changes to “STEP
2“ and “RAISE TO TOP“.
This completes preparation for setting the calibration when
empty.
8. Follow the instructions on the screen and raise the lift arm
fully.
When raising the lift arm, carry out the operation as close
to actual operation as possible.
9. When the setting of the empty calibration is completed cor-
rectly, the buzzer gives short sounds, and the character
display returns to the normal service meter and time dis-
play.
10. If the setting of the empty calibration is not completed cor-
rectly, the buzzer gives a long sound, and the display
returns to “CALIBRATION“ on the top line and “EMPTY
BUCKET“ on the bottom line.
11. Repeat the procedure again from Step 5.