Komatsu PC20R-8, Руководство по эксплуатации и техническому обслуживанию

Страница: 101 / 196

99
TRANSPORTING THE MACHINE ON MOTOR VEHICLES
3.9 TRANSPORTING THE MACHINE ON MOTOR VEHICLES
3.9.1 LOADING AND UNLOADING THE MACHINE
DANGER
•
The loading and unloading of the machine on/from the means of transport must be carried out on a flat
surface and at a safety distance from the edges of ditches or from the road side.
•
Block the means of transport by positioning wedges before and behind each wheel.
•
Make sure that the ramps are sufficiently strong; if necessary, reinforce them with blocks, in order to
prevent any dangerous bending.
•
Make sure that the ramps have the same length, are firmly anchored to the motor vehicle, are parallel to
each other and perpendicular to the loading board; the distance between the ramps must be suitable
for the machine gauge.
•
Position the ramps with a maximum inclination of 15°.
•
Remove any trace of oil, grease or ice from the ramps and the loading board.
•
Do not change direction when the machine is already on the ramps; if necessary, go down and find the
correct direction.
1 - The machine must get on the ramps with the bucket (1) di-
rected forward and raised from the ground.
2 - Once the machine has been loaded, rotate the upper struc-
ture by 180° and engage the antirotation lock, lower the blade
(2) and the work equipment to the ground and shift the safety
device lever to the lock position.
3 - Stop the engine and remove the ignition key.
4 - Keep the machine in position also by putting wedges (3) be-
fore and behind the tracks.
5 - Fix the machine with tie-downs or chains (4) in the anchorage
points (6).
6 - Protect the end of the exhaust pipe (5).
RWA06030
6
RWA07450
4 1 3 4 3 5 2
Max. 15
°