Komatsu GALEO BR550JG-1, Руководство по эксплуатации и техническому обслуживанию

Страница: 283 / 291

.
ATTACHMENTS, OPTIONS
RADIO CONTROL UNIT
SAFETY CHECK
WARNING
Before starting the work, check that there is nobody or no obstacle in the surrounding and sound a horn for caution.
Particularly when using the radio control unit, pay special attention to the machine and the surrounding, and start using the radio
control unit only after judging that there is no safety problem around at all.
Check list when starting work
(Conduct a cloth check based on this check list)
1. Check that there is no damage on the safety devices of the transmitter.
Check the switches and the other vital parts for any damage. If any, do not start the work until after that damaged
part is properly repaired.
2. Check that the POWER switch of the unit is set at the OFF position.
3. Install the charged batteries in the battery holder at the bottom of the transmitter.
4. Turn the POWER switch key of the unit to switch on the transmitter.
5. The transmitter's red lamp begins to flash.
6. The transmitter's green lamp begins to flash about two seconds after that and at the same time the revolving
working lamp (blue) comes on.
With this, the unit is ready for operation.
NOTICE
As long as the TRANSMISSION STOP switch remains depressed, the work equipment cannot be started.
Release the switch by depressing it again and start the work equipment.
To check if the radio control unit is properly functioning, follow the procedures explained below.
1) Set the engine starting switch in the main control box to the ON position.
2) Turn the radio control unit ON/OFF switch in the main control box to the ON side.
3) Set the POWER switch in the transmitter to the ON position.
4) Pull the TRANSMISSION STOP switch in the transmitter. The revolving working lamp on the machine
comes on.
The radio control unit may be operated now.
REPLACEMENT OF BATTERY
WARNING
When the charged level in the batteries goes down, the red lamp begins to
flash. In that case, take the following actions promptly.
Move the machine to a safe place, or bring it under safe conditions
within 30 seconds, using the radio control unit.
The transmitter is put in the STOP mode in 30 seconds.
Turn the POWER switch to the (0) position and switch off the
transmitter.
Pull out batteries (1) from the battery holder, pushing them a bit forward.
Insert charged replacement batteries.
The radio control unit is now ready for use again.
6 - 25
https://tractormanualz.com