Komatsu GALEO BR550JG-1, Руководство по эксплуатации и техническому обслуживанию

Страница: 159 / 291

.
OPERATION
LONG-TERM STORAGE
LONG-TERM STORAGE
BEFORE STORAGE
When putting the machine in storage for a long time, do as follows.
Clean and wash all parts, then store the machine indoors. If the machine has to be stored outdoors, select level
ground and cover the machine with a sheet.
Lubricate and change the oil before storage.
Disconnect the negative terminal of the battery and cover it, or remove from the machine and store it separately.
If the ambient temperature is expected to drop below -0
°
C, always add antifreeze to the cooling water. Since
Komatsu genuine Super Coolant (AF-ACL) is added to the coolant water normally, it is not necessary to add any
other antifreeze as long as the temperature is not expected to drop be -10
° C.
If the temperature may drop below -10
°
C, adjust the density of the coolant according the section of "CLEAN
INSIDE OF COOLING SYSTEM (PAGE 4-28)".
Grease the exposed surface of piston rods of all the hydraulic cylinders (raising and lowering cylinder of the
primary belt conveyor, optional hopper opening and closing cylinder and optional side conveyor storing cylinder).
Set the travel safety lock to the LOCK position.
DURING STORAGE
WARNING
If it is necessary to perform the rust-prevention operation while the machine is indoors, open the doors and windows to improve
ventilation and prevent gas poisoning.
Operate the engine and move the machine for a short distance once a month so that a new film of oil will be coated
over movable parts and component surfaces. At the same time, also charge the battery.
AFTER STORAGE
NOTICE
If the machine has been stored without carrying out the monthly rust-prevention operation, consult your Komatsu distributor
before using it.
When using the machine after long-term storage, do as follows before using it.
Wipe off the grease from the hydraulic cylinder rods.
Be sure to apply oil and grease to all the parts requiring lubrication.
STARTING MACHINE AFTER LONG-TERM STORAGE
When starting the engine for the first time after a long storage period, observe the following procedures.
1. Turn the starting switch key to the ON position.
2. Turn the fuel control dial from the low idling (MIN) position to the full speed (MAX) position, and hold on at that
position for three seconds. Then return the dial to the low idling position and start the engine.
3 - 110
https://tractormanualz.com