Vers. 100822 Page 4
MAIN MENU:
- - - - - M A I N - M E N U - - - - - -
O K c h a n g e E S C q u i t
P r o g r a m s e t t i n g
S e q u e n c e s e t t i n g
Program setting
:
It indicates the menu section where you can set or modify the fastening parameters.
IMPORTANT: To work with switch box, socket tray and remote it is mandatory to go to Sequence
Menu (Ext Box: ON).
Sequence:
It indicates the menu section where you can activate the sequence, the switchbox/socket tray and
the bar code.
NB: It is not possible to set a sequence containing programs both in % and in # mode. See the dedicated
Section.
- - - - - M A I N - M E N U - - - - - -
S e q u e n c e s e t t i n g
U n i t o p t i o n s
U S B o p t i o n s
Unit Options:
It indicates the menu section where you can set date the language, the password, the unit, the
buttons, the unit mode, date and time, the firmware version, the serial number and the cycles done.
USB Options:
It indicates the menu section where
you can view, upload and create programs setting of
the control unit.
PROGRAM MENU:
- - - - - M E N U - - P R : 1 - - - - -
O K c h a n g e E S C q u i t
1 ) P r o g r a m n u m b e r : 1
2 ) S c r e w s n u m b e r : 1
1) Program number:
you can select/ modify the desired program from 1 to 8.
2) Screws number:
The EDU2AE/TOP/TA can act as screw counter. You can set the number of screws
from 1 to 99. To disable the function press
until you get to OFF.
If the number of correct screws matches to the number of set screws, “
PROGRAM END
” will appear on the
status bar and the yellow led will light up. If the “
Press OK
” is OFF (see point 18), “
PROGRAM END
” will
automatically disappear at next screwing or any time you enter the menu. Otherwise, press OK at the end of
each program.
ATTENTION: Every time you enter the menu, the number of screws will reset.
