Kollmorgen AKMH, Инструкция по эксплуатации

Страница: 53 / 74

15.3 Trouble Shooting
The following table is to be seen as a “First Aid” box. There can be a large number of dif-
ferent reasons for a fault, depending on the particular conditions in your system. The fault
causes described below are mostly those which directly influence the motor. Peculiarities
which show up in the control loop behaviour can usually be traced back to an error in the
parameterization of the drive. The documentation for the drive and the setup software
provides information on these matters.
For multi-axis systems there may be further hidden reasons for faults.
Fault Possible cause
Measures to remove the cause of the
fault
Motor doesn’t
rotate
— Drive not enabled
— Break in setpoint lead
— Motor phases in wrong sequence
— Brake not released
— Drive is mechanically blocked — Supply ENABLE signal
— Check setpoint lead
— Correct the phase sequence
— Check brake controls
— Check mechanism
Motor runs away
— Motor phases in wrong sequence — Correct the phase sequence
Motor oscillates
— Break in the shielding of the feedback cable
— amplifier gain to high — Replace feedback cable
— use motor default values
Error message:
brake
— Short-circuit in the supply voltage lead to
the motor holding brake
— Faulty motor holding brake
— Remove the short-circuit
— Replace motor
Error message:
output stage fault — Motor cable has short-circuit or earth short
— Motor has short-circuit or earth short — Replace cable
— Replace motor
Error message:
motor temperature
— Motor thermostat has switched
— Loose feedback connector or break in
feedback cable
— Wait until the motor has cooled
down. Then investigate why the
motor becomes so hot.
— Check connector, replace feedback
cable if necessary
Brake does not
grip
— Required holding torque too high
— Brake faulty
— Motor shaft axially overloaded — Check the dimensioning
— Replace motor
— Check the axial load, reduce it.
Replace motor, since the bearings
have been damaged
Servomotors AKMH English - 53
Kollmorgen
08/2013
Setup
ENGLISH