Kohler Aegis LH685, Руководство по обслуживанию

Страница: 93 / 172

8.6
Section 8
Electrical System and Components
Test
1. If one side is not firing, check all wiring,
connections, and terminations on that side. If
wiring is okay, replace ignition module and retest
for spark.
If the tester shows spark, but the engine misses
or won't run on that cylinder, try a new spark plug.
If neither side is firing, recheck position of ignition
switch and check for shorted kill lead.
1. Test for spark on both cylinders with ignition
tester, SPX Part No. KO1046. Disconnect one
spark plug lead and connect it to the post terminal
of the tester. Connect the clip to a good ground,
not to the spark plug. Crank the engine and
observe the tester spark gap. Repeat the
procedure on the other cylinder. Remember to
reconnect the first spark plug lead.
Conclusion
Ground Clip
Post Terminal
Test Procedure for Standard CD Ignition
Battery Charging System
General
These engines are equipped with either a 15, 20 or 25
amp regulated charging system. See Figure 8-6 for the
15/20/25 amp system diagram.
NOTE: Observe the following guidelines to avoid
damage to the electrical system and
components:
• Make sure the battery polarity is correct. A
negative (-) ground system is used.
• Disconnect the plug from the rectifier-regulator
and the battery cables before doing electric
welding on the equipment powered by the engine.
• Prevent the stator (AC) leads from touching or
shorting while the engine is running. This could
damage the stator.
Wiring Color Codes
B
L
R
Y
W
P
O
L/R Black
Blue
Red
Yellow
White
Purple
Orange
Blue/Red
Not For Resale
www.SmallEngineDiscount.com