Kohler Aegis LH685, Руководство по обслуживанию

Страница: 157 / 172

11.20
Section 11
Reassembly
NOTE: Before installing the flywheel make sure the
crankshaft taper and flywheel hub are clean,
dry, and completely free of lubricants. The
presence of lubricants can cause the flywheel
to be overstressed and damaged when the hex
flange screw is torqued to specifications.
NOTE: Always use a flywheel strap wrench or holding
tool to hold the flywheel when tightening the
flywheel fastener. Do not use any type of bar
or wedge to hold the flywheel, as component
damage and personal injury could result.
1. Install the woodruff key into the keyway of the
crankshaft. Make sure that the key is properly
seated and parallel with the shaft. See Figure
11-67.
NOTE: Make sure the flywheel key is installed
properly in the keyway. The flywheel can
become cracked or damaged if the key is
improperly installed.
Figure 11-67. Installing Key in Flywheel End of
Crankshaft.
2. Thread the two starter mounting bolts into the
hub of flywheel, or use the flywheel puller to serve
as a "handle" and set the flywheel in place. See
Figure 11-68.
Figure 11-68. Installing Flywheel.
3. Install the hex. flange screw and washer. See
Figure 11-69.
Figure 11-69. Installing Flywheel Mounting
Hardware.
4. Use a flywheel holding tool to hold the flywheel
and torque the hex. flange screw to 66.4 N·m
(49 ft. lb.). See Figure 11-70.
Figure 11-70. Torquing Flywheel Bolt.
Not For Resale
www.SmallEngineDiscount.com