Kohler Aegis LH685, Руководство по обслуживанию

Страница: 59 / 172

5B.21
Section 5B
EFI Fuel System
5B
4. Check how the end of the throttle linkage aligns
with the bushing hole in the governor lever. See
Figure 5B-32. It should fall in the center of the
hole. If it doesn’t, perform the adjustment
procedure as follows.
Figure 5B-32. Throttle Link in Center of Hole.
B. Setting the Initial Adjustment
1. Check the split where the clamping screw goes
through the governor lever. See Figure 5B-33.
There should be a gap of at least 1/32". If the tips
are touching and there is no gap present, the lever
should be replaced. If not already installed,
position the governor lever on the cross shaft, but
leave the clamping screw loose.
Figure 5B-33. Checking ‘‘Split’’ of Clamp.
2. Follow the instructions in Step 2 of ‘‘Checking the
Initial Adjustment,’’ then reattach the throttle
linkage to the governor lever with the bushing clip.
It is not necessary to reattach the damper or
governor springs at this time.
If the governor/throttle components are all intact, but
you think there may be a problem with the adjustment,
follow Procedure A to check the setting. If the governor
lever was loosened or removed, go immediately to
Procedure B to perform the initial adjustment.
A. Checking the Initial Adjustment
1. Unsnap the plastic linkage bushing attaching the
throttle linkage to the governor lever. See Figure
5B-30 Unhook the damper spring from the lever,
separate the linkage from the bushing, and remove
the bushing from the lever. Mark the hole position
and unhook the governor spring from the governor
lever.
Figure 5B-30. Throttle Linkage/Governor Lever
Connection.
2. Pivot the throttle shaft and plate into the “Full
Throttle” position, so the tang of the throttle shaft
plate is against the manifold casting. See Figure
5B-31. Temporarily clamp in this position.
Linkage
Bushing
Throttle
Linkage
Damper
Spring
Figure 5B-31. Clamping Throttle Against Stop.
3. Rotate the governor lever and shaft
counterclockwise until it stops. Use only enough
pressure to hold it in that position.
Not For Resale
www.SmallEngineDiscount.com