Kohler Aegis LH685, Руководство по обслуживанию

Страница: 153 / 172

11.16
Section 11
Reassembly
Figure 11-51. Water Pump Torque Sequence.
NOTE: When installation is complete, the tangs
of the two hose clamps should face
outward, away from the flywheel and
slightly down. See Figure 11-52.
3
5
2
4
6
1
Figure 11-52. Transfer Tube Hose Clamp(s) Detail.
9. Push down on the formed tube and hold in this
position to prevent it from pivoting upward when
tightening the hex. cap. Torque the hex. cap to
22.6 N·m (200 in. lb.), to secure the joint
connection. Support the fitting with a wrench while
torquing, if possible, to prevent applying
unnecessary pressure on fitting and joint. See
Figure 11-53. Check that the formed tube and hose
section have not been pulled up.
Figure 11-53. Torquing the Hex. Cap on Fitting
After Pump Installation.
10. Install the drive belt onto the cogged pulley of
water pump, then around the cam pulley. Slide the
cam pulley, with the belt attached, down onto the
keyway end of the camshaft. Be careful not to
push the key out of the keyway and/or into the
seal when installing the pulley. See Figure 11-54.
Figure 11-54. Installing Cam Pulley and Belt.
11. Check or use a feeler gauge to see that there is at
least 3.17 mm (0.125 in.) clearance between the
underside of the pulley, and the hose, tube, and
clamps. Remove the pulley and reposition the tube
or clamps if required. Install the flat washer and
hex. flange screw, to secure the pulley in place.
Torque the screw to 9.9 N·m (88 in. lb.). See
Figure 11-55.
Not For Resale
www.SmallEngineDiscount.com