Kohler 3.5EFOZ, Сервисная инструкция

Страница: 74 / 116

TP-6137 5/03 62 Section 10 Generator and Engine Disassembly/Reassembly
Figure 10-20 Stator Housing
5. Tighten the four M10 x 140 screws at the specified
torque. See section 1.5. See Figure 10-21.
Figure 10-21 Alternator Connection
6. Put the holes of the alternator bracket on the two
vibromount mounting bolts and screw the two M8
nuts at the specified torque (see section 1.5) with a
13 mm socket wrench.
7. Tighten the 27 mm nut of the seawater pump shaft
at the specified torque (see section 1.5) to
strengthen the tapered connection between the
rotor and the alternator through stud.
See
Figure 10-22.
Figure 10-22 Seawater Pump Shaft
Seawater Pump Installation
1. Assemble on the rear side of the stator housing the
seawater pump housing. Tighten the three M5 x 40
screws at the specified torque (see section 1.5)
with a 4 mm setscrew wrench.
2. Push the impeller in the housing turning it slowly
until it is on the shaft. See Figure 10-23.
Figure 10-23 Seawater Pump Impeller
3. Set the O-ring and install the seawater pump cover.
Tighten the four M4 x 8 screws at the specified
torque (see section 1.5) with a 6 mm socket
wrench.
Note: Check the generator set’s nameplate to verify the
original voltage configuration. See Section 10 for
more
information regarding voltage
reconnection.
4. Reconnect all external connections—the exhaust
line to the mixing elbow, the fuel lines, the water line
to the seawater pump, the remote panel, the AC
output leads, and the battery cable to the battery
(negative (--) lead last).
5. Open the seacock and the fuel valve.