Koden MDC-5204, Руководство по установке

Страница: 73 / 182

MDC-5200/5500 Series Chapter 4 Setup after installation
0092655002-03 4-3
4.1.2 Heading adjustment (HL OFFSET)
Bearing compensation due to installation can be adjusted.
(1)
Change the range scale to 1 NM or more by pressing “+” (or “-”) key on the Operation unit.
(2) Select a visible fixed object as far as possible and measure its bearing using magnetic compass
or equivalent. Measure the bearing of the same target on the radar display. Adjust it according to
the following procedures when both values differ 1 degree or more.
(3) Press MENU
key to display “Menu”.
Select [MAINTENANCE] => [STARTUP] => [HL OFFSET] => [VALUE] will show the current
setting of the input value by highlighting the last digit value by the trackball/joystick.
(4) Move the trackball/joystick up or down to adjust the value to match the bearing value of the
target picture to the compass value.
(5) Press ENT key to save the adjustment result.
Adjustable value: -180.0 to +180.0
Note: When you use inter-switch mode at first time, please set Heading (HL OFFSET) adjustment of
each antenna. These setting data are memorized in non-volatile memory, and applied
automatically when each antenna is setected.
Direction of HL OFFSET
“+”
Direction of HL OFFSET
“-“