Koden MDC-5204, Руководство по установке

Страница: 63 / 182

MDC-5200/5500 Series Chapter 3 Installation method
0092655002-03 3-39
3.4.3 KODEN GPS compass connection
When using the KODEN GPS compass (KGC-1, KGC-222), connect the J6 port of the Display unit to
DATA2 connector of KGC-1/ DATA1 or DATA2 connector of KGC-222. This connection allows high
data speed.
The procedure to Switch to high-speed communication mode
(1) Press MENU key to display
“Menu”
Select [MAINTENANCE] => [I/O] = [KGC SET] => [INITIAL] => [GO]
(2) Press ENT key.
The communication baud rate is set to 38400 bps (IEC61162-2) or both Display unit and GPS
compass. Start the GPS compass to output HDT, GGA, VTG and ZDA sentence signals.
Refer to 4.2.11 Setup KGC (GPS compass)
Note: The KGC-1 DATA2 port or KGC-222 DATA1/DATA2 port (connecting port to radar) is set as
38400 bps, signal type: HDT, GGA, VTG and ZDA by this initialization. When these ports of GPS
compass is used for another device that cannot handle this baud rate setting, connect radar to
another port and do not perform initialization.
GPS compass
KGC-1 or KGC-222
Figure 3.20 Cable connection between Display unit and KODEN GPS compass
CW-373
J7
J5
J6
J6