Device Status
You can check the status of the unit, such as remaining ink level.
Device Configuration
General Settings
You can change the following items.
●
Default paper size/type
If you change this setting, the default paper size/type in Copy
Menu setting are also changed.
●
Sleep mode time
You can change the time required before unit enters Sleep mode
from
[1 min / 10 min / 20 min / 30 min / 40 min / 50 min / 60 min /
70 min / 80 min / 90 min / 100 min / 110 min / 120 min]
.
Print Reports
You can print out the configuration report.
Factory Reset
You can restore the default settings to the unit.
Note(s)
●
The unit will automatically restart after reset to factory
settings. (The Web Interface will be disconnected.)
The network connection will be disconnected.
Network
If necessary, you can confirm or set the state of the Network. If you
are not familiar with Network management, use the default settings.
Note(s)
●
Be careful if you want to assign the IP address manually. If
the IP address you entered is not correct, you will not be
able to connect to the unit. When you cannot connect to
the unit after a configuration change, please reset the unit
to the factory default.
» Refer to “Restore Factory Default” on page 45.
●
When the connection of the unit is changed, the Web
interface will be disconnected. If necessary, reconnect the
Web interface.
Enable Wi-Fi
You can turn On / Off the Wireless function.
Note(s)
●
Even if the Wireless function is set to Off, when you connect
by Easy Simple Print, the Wireless function will be valid.
●
When you have connected the unit to the access point/
router, if you disable Wi-Fi, you will not be able to operate
from the Web Interface. If you connect to Wi-Fi again, press
(Wireless).
47
English
Continued on next page.
