Kodak RP X-OMAT M6B, Руководство по обслуживанию, Страница: 74 / 161

Component Checkout Procedure
.
Flow of Water to the Processor
(1) Check the flow of water. It should take approximately 2 minutes and
30 seconds to fill the WASH TANK with the RACK ASSEMBLY
installed.
Chemical Replenishment (1) Check for the correct replenishment rates. See Service Bulletin
No. 30.
Tubing (1) Check that all TUBING is not kinked or damaged.
Strainer Assemblies (1) Check the STRAINER ASSEMBLY for dirt by doing the following steps.
a. Place a CLAMP on the TUBING.
b. With a BRUSH and warm water clean the STRAINER ASSEMBLY
to remove all dirt and chemical deposits from the SCREENS.
Dryer
Drive Belt (1) Check the DRIVE BELT for wear. Install a new DRIVE BELT if
necessary.
(2) Check that the DRIVE BELT is adjusted for the correct tension.
Bearings (1) Check the BEARINGS in the upper and lower PULLEY ASSEMBLIES
for wear.
Air Tubes (1) Check that the AIR TUBES are clean.
Rollers (1) Check that the ROLLERS are clean and smooth.
(2) Check that the ROLLERS are correctly seated.
O-Rings (1) Check the O-RINGS for wear and cracking. Install new O-RINGS if
necessary.
Supports (1) Check that the SUPPORTS are clean.
Dryer Temperature (1) Check the drying temperature to make sure it is set within the specified
range. If the film is not drying, adjust the temperature.
Blower Belt (1) Check the BLOWER BELT for wear. Install a new BLOWER BELT if
necessary.
(2) Check that the BLOWER BELT is adjusted for the correct tension.
Pulleys, Blower, and Blower (1) Check the PULLEYS for clicking noises. If clicking noises are heard,
Motor tighten the 2 setscrews on the MOTOR or BLOWER PULLEYS.
(2) Check the alignment of the BLOWER BELT. Adjust the alignment if
necessary.
3-8 246628