Kodak RP X-OMAT M6B, Руководство по обслуживанию, Страница: 72 / 161

Component Checkout Procedure
.
Squeegee Assembly
Rollers (1) Check that the DRIVEN ROLLERS and IDLER ROLLERS rotate freely.
(2) Check that the ROLLERS are clean and smooth.
Gears (1) Check the GEARS of the ROLLERS for broken TEETH. Install new
ROLLERS if necessary.
(2) Check the ROLLERS for wear and burrs. Install new ROLLERS if
necessary.
(3) Check the SQUEEGEE ASSEMBLY for the correct alignment by doing
the following steps.
a. Remove the SQUEEGEE ASSEMBLY from the processor.
b. Place the top side of the SQUEEGEE ASSEMBLY on a flat,
smooth surface.
c. Check that the SIDE PLATES are square against the flat, smooth
surface.
d. Check that the SQUEEGEE ASSEMBLY seats correctly when you
install it.
(4) Check that the LONGER TIPS are in the direction of the film travel.
Bearing, Brackets, and Nuts (1) Check the BEARINGS, BRACKETS, and NUTS for wear and broken
parts. Install new parts if necessary.
Rack Assemblies
To prevent contamination of the DEVELOPER, use the SPLASH GUARD
and the DRIP TRAY when you remove the FIXER RACK.
(1) Check the RACKS for cleanliness.
Rollers (1) Check that the ROLLERS are clean and smooth.
Sprockets (1) Check that the SPROCKETS are correctly engaged in the RACK
CHAIN.
(2) Check that the RACK is square.
Chain (1) Check that the LINKS of the CHAIN are not damaged. Rotate the
DRIVE GEAR so that the entire CHAIN makes one complete revolution
over the DRIVE SPROCKETS.
(2) Check that the tension of the CHAIN is correct. A CHAIN that is not
adjusted correctly may cause the ROLLERS to rotate incorrectly and
may cause the BEARINGS to wear excessively.
3-6 246628