Kodak RP X-OMAT M6B, Руководство по обслуживанию, Страница: 50 / 161

[5] Compare the average of 2 or more measurements with the film and chemical specifications of the
manufacturer.
[6] If necessary, adjust the rate by doing the following steps:
Do not adjust the SETSCREW or the LOCK NUT.
a. Remove the PUMP COVER by loosening the 2 SCREWS on the top of the PUMP and lifting the PUMP
COVER off.
b. Rotate the CRANK by hand to access the ADJUSTING SCREW.
c. Rotate the appropriate DEVELOPER or FIXER ADJUSTING SCREW to obtain the correct replenishment
rate.
[7] Install the PUMP COVER onto the PUMP.
H048_0104BA
CRANK
ADJUSTING SCREW
OUTPUT
DECREASE INCREASE
STROKE INDICATOR
STROKE SCALE
SET SCREW
(DO NOT ADJUST)
PUMP
COVER
SCREW (2)
H048_0104BCA
Figure 42 Adjusting the Replenishment Rate
NOTE
Refer to the manufacturer’s specifications, for the film and chemicals being used. For operating
temperatures and replenishment rates, refer to the KODAK RP X-OMAT Processor Service
Bulletin No. 30 in this manual.
2-38 246628