Antenna
®
Telescope
™
Antenna
®
Telescope
™
Installation Instructions
October 2018
18
Telescope Dual Table Bases with Beam (with or
without Dual Utility Trays) - Standard Electric
13. Slide the ends of (4) rails into the cradles on a
crossbar assembly. Position the rails so that the
end cap (T) sticks out past the cradle by ¼".
Note:
The original Antenna install gauge is
to be used to set Telescope rail positions.
14. Tighten the screws (M) in the
cradle clamp brackets (D).
15. Slide the free ends of the rails into the
opposite crossbar assembly and repeat
the above tightening procedure.
INSTALL UTILITY TRAYS (WHERE APPLICABLE)
16. Insert (2) pairs of 1/4 -20 x 5/8" flanged button
head hex machine screws (X) loosely into the
threaded inserts on the inner face of the crossbars.
Leave a gap of about 3/16" beneath the head
of the screws. Slip the Utility Tray between the
crossbars and engage the upper screws into
the upper slot on the tray end plate. Rotate the
tray so the lower screws engage the bottom
slot. Tighten the screws with an Allen wrench.
17. Insert a M6-1 spring nut (Z), centered, into
the slot on the side of the center beam.
Position a Utility Tray Bracket (Y) in front of the
spring nut (Z) and engage the back edge of the
utility tray within the grooves of the tray bracket.
Fasten the tray bracket to the spring nut with a
M6 – 1 x 14mm flat head machine screw (AA).
Repeat for the other side of the center beam.
INSTALL THE HEIGHT ADJUSTMENT
ELECTRICAL COMPONENTS
18. For each station, decide if the Handset
Control Switch (J) will be on the
left or right side of the table.
Note
: If a return assembly is to be attached
to the primary surface, the handset should
be temporarily located on the same side
as the return attachment. It will ultimately
be relocated to the return assembly.
19. Plug the handset cable into a housing outlet on
the chosen side. Connect one end of the iDrive
Cable into the second outlet on that side and the
other end into an outlet on the opposite side of
the table, (see User Manual for cable diagram).
20. Insert the Power Supply plug into the remaining
outlet on the non-handset side. Insert the power
cord into the power supply and position the
power supply on the nearest Transformer Shelf
(F) so that the green LED is visible from below.
PERFORM A RESET FOR THE PAIR
OF COLUMNS IN EACH STATION:
21. Plug the power supply into a temporary
power source. Ensure the green LED
on the power supply lights.
22. Apply approximately 100 lbs of weight to the
rails . Press and hold both UP and DOWN
buttons for ten seconds. After releasing the
buttons, press and hold the DOWN BUTTON
until both columns bottom out. Press the
UP button and the station will be ready to
perform normally. Remove the weight. Run
the station all the way up and down again to
ensure there are no issues with the columns.
Repeat the procedure above for the
opposite pair of columns.
Dual Table Base with Beam, Utility
Tray Installation, Steps 16 & 17
Dual Utility Tray
M6 – 1 x 14mm Flat Head
Machine Screw (AA)
Utility Tray Bracket (Y)
M6-1 Spring
Nut (Z)
Threaded
Inserts
1/4 -20 x 5/8" Flanged Button
Head Hex Machine Screw (X)
Step 14
Step 13
Steps 18, 19 & 20
Handset Control Switch (J)
iDrive Cable
Power Supply and Power Cord
