28
Turn the “Fine Feed” hand wheel (7-6/1) clock-
wise until the knife no longer touches the grind-
ing wheel.
Turn the selector switch (3-5/2) on the switch box
to “Grind”. The grinding wheels start rotating.
Turn the hand wheel (7-6/1) anti-clockwise until
the knife touches the grinding wheels.
Depending upon how far the hand wheel has
been turned, the grinding pressure and thereby
the material removal rate is raised or lowered.
Take care while unclamping the knife! Sharp knife edge!
Danger of serious cut injuries!
Wear protective gloves.
CAUTION
NOTICE
There are two different switch positions:
• “Hone” for low material removal rate
• “Grind” for high material removal rate
ATTENTION
For double side grinding, turn the rotary
knob (3-5/3) clockwise all the way to the
stop.
After one minute, lift the grinding arm and check
knife sharpness.
Once the grinding process has ended, switch off
the machine and swivel the grinding device hori-
zontally to the right (see Figure 7-1) and unclamp
the knife.
7. Operation
Figure 7-6
Turning the “Fine Feed” hand wheel
clockwise
1
