14
After completion of the maintenance work and fault rectification, install all the safety devices and
check whether they are fully functional.
2.4.10 Structural modifications of the honing machine
Modifications, retrofitting or rebuilds of the honing machine are not allowed without the permis-
sion of the manufacturer. This also applies to the installation and adjustment of safety devices.
No alterations may be carried out without prior written permission from KNECHT Maschinenbau
GmbH.
Immediately replace machine parts which are not in perfect condition.
Use only original replacement and wear parts. If parts are purchased from external suppliers, it
cannot be guaranteed that they will be constructed and manufactured to withstand the stresses
and provide the required level of safety.
2.4.11 Cleaning the honing machine
Cleaning agents and materials used must be handled properly and disposed of in an environ-
ment-friendly manner.
Ensure that wear and replacement parts are disposed of in a safe and environmentally friendly
way.
2.4.12 Oils and greases
When handling lubricants / oils and greases, follow the safety regulations for the product. Observe
special instructions for the foodstuffs sector.
2.4.13 Relocation of the honing machine
Even when moving the honing machine a short distance from its site, disconnect it from all exter-
nal power supply sources. Before restarting the honing machine, connect it properly to the current
supply.
When loading or unloading, only use hoisting and load lifting equipment with sufficient
load-bearing capacity. Appoint a qualified banksman (signaller) for the lifting process.
No persons other than those entrusted with this work may be present in the loading and installa-
tion area.
Only lift the honing machine correctly with a suspension device in accordance with the operat-
ing instructions (attachment points for load suspension devices, etc.). Only use suitable transport
vehicles with sufficient load-bearing capacity. Attach the load securely. Use suitable attachment
points. When putting in operation again, proceed only as instructed in the operating instructions.
2. Safety
