klover ALTEA 110, Установка, использование, техническое обслуживание и полезные советы

Страница: 29 / 40

WOOD BURNING BOILER COOKER ALTEA 110 SICURO TOP
26
EN - Rev. 1.2
To achieve maximum output to the cooking hotplate, push the grate raising lever downwards. This raises the position of
the grate and brings the flame closer to the cooking hotplate; to return the grate to the low position, push the grate
raising lever stop upwards:
The flue and air inlet are the main components for ensuring the correct operation of the cooker and the cooking
hotplate.
In the event of poor flue draught caused by particularly adverse weather conditions (strong wind, low pressure,
etc.),partially close the
internal smoke stream damper without closing it completely. Also adjust the smoke damper on
the flue inlet and/or the flue outlet.
Production of domestic hot water (suitable models only)
Domestic hot water is produced instantly via a double heat exchanger immersed in the water inside the appliance. To
obtain sufficient amounts of hot water, the appliance must have a minimum temperature of 65°C.
If a lot of hot water is needed, manually set the appliance to the "
DHW Function " mode (see section “Elect ronic control
unit ” ) . The purpose of the " DHW Function " is to postpone operation of the heating pump to higher temperatures, so that
all heat is used for hot water. Hence, the circulating pump in the heating system is off during this phase. When working
in
“DHW Function” mode, the timer can be set to delay the pump until 85°C is reached. This function should be disabled,
when hot water is no longer needed (see section “Electronic control unit” ) .
If water is particularly hard, it is essential to install an anti limescale device at the DHW exchanger inlet, to be
chosen according to the water type.
If there is a drop in the quantity or the temperature of hot water, the heat exchanger may need to be cleaned
(chemically) by the installer.
Grate raising lever.
Grate raising lever stop.