RPTR-OBA/734
Installation Manual
REV: B (04/25/2022)
19
7
On-Vehicle Installation
7.1
Nut Plates & Tank/Compressor Bracket Installation
The following brackets & hardware are used in this step:
•
Item 18 = RAPTOR-110
•
Item 20 = RAPTOR-203 – Qty: 2
•
Item 22 = RAPTOR-211
•
Item H2 – Qty: 2
•
Item H3, H8, H10 – Qty: 4 each
1.
Thread H2 into RAPTOR-203 approximately halfway
(REF. Below)
.
2.
Thread Qty: 1 H3 approximately halfway, into left or right hole of RAPTOR-203 temporarily as
shown below.
Figure 13- Nut Plate Preparation – Step 1 (Left), Step 2 (Right)
3.
Locate 2 oval holes on passenger side frame rail in-between the front & rear door as shown.
Figure 14- Raptor-203 Install Location
